苯并口恶嗪-环氧化合物-胺类催化剂体系开环聚合反应的研究

采用TLC，GPC，1H－NMR及IR等分析方法，对苯并恶嗪－环氧化合物－胺类催化剂体系的聚合反应进行了研究，表征了产物结构，并探讨了聚合反应机理，结果表明，苯并恶唪－环氧化合物体系在胺类催化剂如苄胺，咪唑的作用下，能发生开环聚合反应，生成低分子量的聚合物。     

纳米聚N-异丙基丙烯酰胺微凝胶的光引发聚合

选择具有温敏性的高分子单体N－异丙基丙烯酰胺（N－isopropylacrylamide，NIPAM）为主单体，N，N′－亚甲基双丙烯酰胺（methylenebisacrylamide，MBA）为交联剂，运用光引发无皂乳液聚合的方法合成出粒径小于100nm的高分子微凝胶，并研究了在改变体系组成和条件时微凝胶粒径的变化。结果显示，在乳化剂临界胶束浓度以下，随着乳化剂浓度的提高，微凝胶粒子的粒径不断关小且趋向稳定；相比于热引发，产生的微凝胶具有较高的单分散性而且粒径较小。     

Probing the early stages of polymerization of ethylene on a model chromium/silica catalyst by Fourier transform infrared spectroscopy

The nature of the interaction of monomer, and the early stages of growth of oligomers of ethylene on a rather more uniform surface of Cr/SiO₂ catalyst than hitherto studied has been investigated by differenceFTIR spectroscopy using C₂D₄ and C₂H₄ as reactants both with and without subsequent treatment of the catalyst with CO andTHF. The active catalyst was prepared by reaction of vapour phase CrO₂Cl₂ with the vicinal hydroxyls of the silica surface. Three distinct kinds of methylene groups were detected. Arguments are given for assigning the peaks at 2935 and 2860 cm^–1 to CH₂ groups directly bound to the active site and those at 2920 and 2850 to CH₂s in the growing chain well removed from the Cr. The peaks at 2160 and 2165 cm^–1 are attributed to CD₂ groups hydrogen bonded to surface hydroxyls.     

Separation of di- and tripeptides with solvent extraction and an emulsion liquid membrane

The extraction equilibria of various di- and tripeptides with di-2-ethylhexylphosphoric acid (D2EHPA) were studied at low pH values. The complex extracted to organic phase consisted of one molecule of peptide and two molecules of D2EHPA dimer. The extraction constants of the peptides correlated well with the distribution coefficients of peptides between 1-octanol and water, which is a measure of hydrophobicity. The permeation rates of peptides through an emulsion liquid membrane were examined by using D2EHPA as a carrier, Span 80 as an emulsifier and kerosene as a diluent. The rates varied considerably with peptide type, depending upon the hydrophobicity.     

抗坏血酸对核乳胶性能的影响

文章介绍抗坏血酸对核乳胶灵敏度、灰雾密度及潜影衰退性能的影响，并与日本富士ＥＴ－７Ｂ型乳胶的潜影稳定性能在不同温度和相对湿度条件下作相应比较。     

工业聚合反应装置 Ⅴ.流化床气相聚合反应器

简介了流化床气相聚合反应器的原理和6种典型的聚合装置。     

乳化炸药的高温化学发泡

文中在阐述ＮＨ４ＮＯ３－ＮａＮＯ２－Ｈ２Ｏ发泡体系的发泡机制的基础上，推导出了就获得较低的反应速率ｒＲ和气体生成量ｎ的高ｐＨ值对高温的平衡关系，从而提出了高温发泡技术。     

聚醚合成工业齿轮油的研制

以聚醚为基础油辅以抗磨剂、抗氧剂、防锈剂等多种添加剂研制而成的KGW聚醚合成工业齿轮油具有优异的黏温性能和低温性能，优异的极压抗磨性，极优的减摩性能，可满足高负荷、强冲击等苛刻条件下各类齿轮传动装置的润滑要求。该系列产品达到国外同类油品质量水平。     

助催化剂对TiCl_4/MgCl_2催化丙烯高温聚合的影响

研究了助催化剂种类(三甲基铝、三异丁基铝、三正己基铝、三乙基铝和甲基铝氧烷)及其含量对无内、外给电子体的TiCl4/MgCl2催化剂催化丙烯高温(100℃)聚合性能的影响,并用结晶分级分析、示差扫描量热和凝胶渗透色谱等方法分析了所得聚丙烯的结晶熔融行为和微观结构。实验结果表明,聚合温度从70℃升至100℃时,TiCl4/MgCl2催化剂的定向能力基本不变;100℃聚合时,以烷基化能力较弱的三异丁基铝为助催化剂时TiCl4/MgCl2催化剂的活性最高,而采用烷基化能力最强的三甲基铝为助催化剂时TiCl4/MgCl2催化剂的活性最低;100℃聚合时,助催化剂的种类对TiCl4/MgCl2催化剂的定向能力影响很小。     

复合沉淀氯化镨钕工艺研究

针对草酸沉淀成本高的问题，提出了复合沉淀的方法，试验结果及生产应用都证明了此方法能达到降耗同效的目的。